Flash/unbrick or upgrade your device with the firmwares below using odin
Learn how to use odin from here
SAMSUNG GALAXY SM-G130H STOCK FIRMWARE
***************************************************************************************************
SAMSUNG GALAXY SM-G130HN STOCK FIRMWARE
G130HNXXU0ANG2_G130HNBTU0ANG1_BTU
G130HNXXU0ANG2_G130HNOXX0ANG2_ROM
G130HNXXU0ANG2_G130HNBTU0ANG1_BTU
G130HNXXU0ANG2_G130HNOXX0ANG2_ROM
***************************************************************************************************
SAMSUNG GALAXY SM-G130M STOCK FIRMWARE
- Download and install samsung drivers
- Download and launch odin
- Turn off your phone
- Boot phone into download mode by holding vol down + home + power button
- When you see the yellow triangle, press volume up to continue into odin mode
- Now connect the phone to PC using USB cord
- Wait for odin to detect the phone (you will see the COM Port)
- Now click AP in odin interface then select the firmware
- After the firmware is successfully loaded,
- Click Start button
- Wait for process to complete
- When you see PASS in green then the process is complete.
- Wait for the device to reboot
Its always good to do a factory reset after doing this process
For a more detail process on how to flash or upgrade Samsung devices, click here
ReplyDeleteThis article creates a new hope and inspiration with in me. Thanks for sharing article like this. The way you have stated everything above is quite awesome. Keep blogging like this. Thanks.
SAP training in Chennai