Infinix Hot S3 X573 Quick Review
Infinix Hot S3 runs on Android 8.0 Oreo themed with XOS themed with Humming bird 3.0.
This device is a 5.6-inch ips touchscreen display with a resolution of 720 X 1440 pixels 293ppi. A size of 153.3 x 72.8 x 8.4 mm and weighs about 150g.
This device is a 5.6-inch ips touchscreen display with a resolution of 720 X 1440 pixels 293ppi. A size of 153.3 x 72.8 x 8.4 mm and weighs about 150g.
Powered by 1.4GHz octa-core Qualcomm processor Snapdragon 430 with Adreno 305 GPU and 3GB of RAM. There’s also 32GB of internal storage which can be expanded up to 128GB with microSD.
There is a 13 MP primary camera with LED Flash and a 20-mega pixel front selfie camera.
This is a dual SIM Phone with other connectivity options like Wi-Fi, GPS and Bluetooth 4.0. Support GSM + WCDMA + 4G LTE networks. Sensors on this phone include fingerprint, Compass Magnetometer, Ambient light sensor, Accelerometer, Proximity sensor and Gyroscope.
X573-QL1668DEF-O-IN-180313V30
How to flash this device using Qualcomm Image Flash Loader
Note
Follow the instructions on how to flash the device carefully below
I will not take responsibility on whatever may happen to your device.
Flash at your own risk..
Make sure you are downloading the exact ROM of the device you want to flash because
flashing a wrong preloader, will make the device completely dead
(can't power on, can't charge and will not be detected by a computer)
Download an install the latest version of QPST from here
Download an install Qualcomm usb drivers from here
Under Build type, select (tick) Flat Build
Under Select Programmer, Click Browse button then navigate to firmware folder open images folder and select prog_emmc_firehorse_XXXXX.mbn file.
Click on Load XML and select rawprogram0.xml and Patch0.xml
Open back cover of the device disconnect battery and then connect the phone to PC
Now bridge the test points as shown on image below with a pair of twizzers or metal to put infinix X573 into EDL mode.
Port will now appear on QFIL tool.
Click Download button and wait for flash process to complete.
When process is complete, disconnect and boot up device.
Note that first boot after flash process takes longer than usual.
For a more detail tutorial on how to flash this device with QFIL, click here
Like and share
No comments:
Post a Comment