Asus Zenfone 2 Quick Review
Ulefone Amour runs on Android 5.0 Lollipop upgradeable to 6.0 Marshmallow with Asus ZenUI.

This device is a 5.5-incher with ips touchscreen display with a resolution of 1080 X 1920 pixels ~401ppi. size of 152.5 x 77.2 x 10.9 mm and weighs about 170g.

2.3GHz quad-core processor intel atom Z3580 chipset with 3GB of RAM model and 1.8GHz quad-core processor intel atom Z3560 chipset with 2GB of RAM model. There’s also 16/32/64GB of internal storage which can be expanded up to 256GB with microSD. 

There is a 13MP primary camera with LED Flash and a 5-megapixel front selfie camera.

This is a dual SIM Phone with other connectivity options like Wi-Fi, GPS and Bluetooth 4.0. Supports GSM+HSPA+LTE networks. Sensors on this phone include Compass Magnetometer, Ambient light sensor, Accelerometer, Proximity sensor and Gyroscope.

This device is powered with a 3000mAh non-removable battery

WW_ZE551ML_2.15.40.13_20150506 (firmware is compatible with AD/ADA/ADB/ADC variants )

How to flash this device using Asus Flash Tool

Follow the instructions on how to flash the device carefully below
I will not take responsibility on whatever may happen to your device.
Flash at your own risk...

Make sure you are downloading the exact ROM of the device you want to flash because 
 flashing a wrong firmware, will make the device completely dead 
(can't power on, can't charge and will not be detected by a computer)

Download and install Asus Android drivers from here
Download and install Asus Flash Tool here
Launch Asus Flashtool
Under Model, select FE170CG
Wipe Data select Yes
Now click the browse button then navigate and select the raw firmware zip file downloaded.
Turn device off then press and hold volume up & down with power key for about 3 secs to enter droidboot or fastboot mode.
Connect device to PC with USB cord
Asus Flash Tool will detect device
Press start button and wait for flash process to complete
Phone will reboot when process is complete.

If you do not want to use Asus Flashtool, you can just extract the raw firmware zip file.
Launch flashall-softuse.bat file inside the extracted folder.
Boot device into droidboot/fastboot mode by a press and hold of volume up + down and power key for about 3 seconds.
Connect device to PC with USB cord.
Flash process will begin
Wait for process to complete.
Phone will reboot when flash process is done.

Hope this helps

Like and Share

No comments:

Post a Comment

Related Posts

Related Posts Plugin for WordPress, Blogger...