Asus Fonepad 7 Quick Review
Ulefone Amour runs on Android 4.3 upgradeable to 5.1 Lollipop.

This device is a 7.0-incher with ips touchscreen display with a resolution of 1024 X 600 pixels. A size of 192 x 110 x 10.7 mm and weighs about 290g.

Powered by 1.2GHz dual-core processor intel atom Z2520 chipset with 1GB of RAM. There’s also 4/8GB of internal storage which can be expanded up to 64GB with microSD. 

There is a 2MP primary camera with LED Flash and a VGA-megapixel front selfie camera.

This is a dual SIM Phone with other connectivity options like Wi-Fi, GPS and Bluetooth 4.0. Supports GSM+WCDMA networks. Sensors on this phone include Compass Magnetometer, Ambient light sensor, Accelerometer, Proximity sensor and Gyroscope.

This device is powered with a 15Wh non-removable battery

WW_FE170CG_V11.2.3.33-raw_2015 (Android 4.4 for use only on WW Variant)

How to flash this device using Asus Flash Tool

Follow the instructions on how to flash the device carefully below
I will not take responsibility on whatever may happen to your device.
Flash at your own risk...

Make sure you are downloading the exact ROM of the device you want to flash because 
 flashing a wrong firmware, will make the device completely dead 
(can't power on, can't charge and will not be detected by a computer)

Download and install Asus Android drivers from here
Download and install Asus Flash Tool here
Launch Asus Flashtool
Under Model, select FE170CG
Wipe Data select Yes
Now click the browse button then navigate and select the raw firmware zip file downloaded.
Turn device off then press and hold volume up & down with power key for about 3 secs to enter droidboot or fastboot mode.
Connect device to PC with USB cord
Asus Flash Tool will detect device
Press start button and wait for flash process to complete
Phone will reboot when process is complete.

If you do not want to use Asus Flashtool, you can just extract the raw firmware zip file.
Launch flashall-softuse.bat file inside the extracted folder.
Boot device into droidboot/fastboot mode by a press and hold of volume up + down and power key for about 3 seconds.
Connect device to PC with USB cord.
Flash process will begin
Wait for process to complete.
Phone will reboot when flash process is done.

Hope this helps

Like and Share

No comments:

Post a Comment

Related Posts

Related Posts Plugin for WordPress, Blogger...